Frequency Generator in Top Hat Rail Casing
HG G-57405
A frequency generator generates an alternating current in a conductive loop for guidance of driverless transport vehicles (FTF). The circuit board contains a generator with power amplifiers and a transformer for DC decoupling. The operating frequency can be selected via a HEX rotary switch with 16 positions.
The generator generates a constant output current. Short circuits or too low load impedances as well as loop interruptions or too high load impedances are indicated by an LED on the front panel and a potential-free fault signal output. The frequency generator has separate connections for long or short loops. The maximum load impedance differs between long and short loops in a ratio of about 1:2. The loop current can be adjusted via a trimming potentiometer on the front panel.
Synchronization of generators (not available for variant QF)
Up to 7 generators can be synchronized to avoid beatings when using the same frequencies. Further information can be found on the back.
A frequency generator generates an alternating current in a conductive loop for guidance of driverless transport vehicles (FTF). The circuit board contains a generator with power amplifiers and a transformer for DC decoupling. The operating frequency can be selected via a HEX rotary switch with 16 positions.
The generator generates a constant output current. Short circuits or too low load impedances as well as loop interruptions or too high load impedances are indicated by an LED on the front panel and a potential-free fault signal output. The frequency generator has separate connections for long or short loops. The maximum load impedance differs between long and short loops in a ratio of about 1:2. The loop current can be adjusted via a trimming potentiometer on the front panel.
Synchronization of generators (not available for variant QF)
Up to 7 generators can be synchronized to avoid beatings when using the same frequencies. Further information can be found on the back.
Overview
- One-loop frequency generator for track guidance of automated guided vehicles (AGV)
- Alternating current generation with a current intensity of up to I = 600mA
- For use with guide wire antennas
- One of 16 frequencies selectable
- Quartz stabilized frequency generation, accuracy better than 0.02 %
- Mountable on 35 mm top hat rail
- All models except QF: Synchronizable up to 5.1 kHz, max. 6 sub masters, max. 6 slaves per master/sub master
- Only model QF: Switch-on via control input
Versions with different pre-set frequencies are available, please see the data sheet below.
Technical data
| Dimensions | 204 mm x 105 mm x 69,1 mm (B x H x D without connector) |
| Weight | ca. 1020 g (incl. connector) |
| Temperature ranges | Operation: 0° C to +50° C / Storage: -20° C to +70° C |
| Supply voltage | + 24 V ±25 % |
| Frequency output | Depending on variant and position of HEX rotary switch |
| Frequency accuracy | better than 0,02 %, quarz stabilized |
| Output current | Imin = 35 mA Imax = 600 mA |
| Output voltage | 4 to 24 V on the long loop 2 to 12 V on the short loop |
| Current consumption |
1.1 A at full output @ Ub = +24 V |
| Connnection | Terminal block 18 pin, connector for cables up to max. 1.5 mm², Phoenix Contact DFMC1,5/9 -ST-3,5 (179019), 1x within scope of delivery |
Downloads
Contact
Get in touch with us.
We look forward to your call or message.
Your contact person:
Mr. Gregor Wallbaum
Tel. +49 5136 8096 – 142
sales@goetting.de
