Technical data | Downloads | Contact

Transponder Programmer
HG G-81840

The transponder programmer HG G-81840 is used for reading and programming RFID transponders. The code to be programmed can be entered comfortably via a keyboard and the color display. Likewise the read code is shown together with the signal strength.

The device has an internal rechargeable battery that has enough capacity for about 12 hours of independent operation. The battery can be charged via the device‘s USB type C interface.

Overview

Ergonomic programmer for Goetting transponders
Frequency range see table Variants below
Compact handheld housing
Graphic display 3.5“
Detachable transmit and receive antenna
Intuitive user guidance
With universal charger

Variants

HG G-81840 ZA

Blue decoration seal
Frequency range 125 kHz, 128/64 kHz and 409 kHz

HG G-81840 YA

Green decoration seal
Frequency range 13,56 MHz

Supported transponder types

Variant HG G-81840ZA

HG G-70633ZA/ZB
HG G-70653ZA
HG G-70654ZA/ZB
HG G-71325ZA/YA/XA
HW DEV00033/34
HW DEV00095/98
HW DEV00127/128

Variant HG G-81840YA

HG G-70661XA/YA

Technical data

Dimensions	See sketch above
Casing	ABS with shock protection seal (TPE)
Weight	600 g
Internal voltage supply	Li-Ionen battery, 3,6 V, 4500 mAh
External voltage supply	5 V DC via USB Typ C (operation and charging, operation has priority)
Current consumption	Max. 500 mA / 1A automatic detection
Protection class	IP65
Temperature ranges	Operation & storage: -20° C to +60° C
Relative humidity	95 % to 25°C (without condensation)
Read/write range	40 to 100 mm (depending on the transport type)
Connections	• Charging socket: USB Typ C • Antenna: Snap-In connector with magnetic holder